User's Manual

CHAPTER 8 NDA-24300
Page 542
Issue 1
CMOD: Change of System Mode
CMOD:
Change of System Mode
1. Functional Outline
This command is used to execute ACT/ST-BY change of the processor (CPU)/TSW and display the status of
CPU/CLK/TSW.
2. Parameters
Input Data
TYPE: Type of Process (1,2)
1/2=Change Operating Mode/Make Busy of TSW
DEVICE: Device to be changed (1,2)
Note 1
1=CPU
Note 2
2=TSW
SW: Type of Switch
Note 3
1=TSW (fixed)
SYSTEM: System of Switch (0,1)
Note 3
0/1=System 0/System 1
Note 1:
This parameter appears only when TYPE=1.
Note 2:
When the CPU mode change is executed, the MAT (TCP/IP) is once disconnected. Then, log in to the system
again.
Note 3:
This parameter appears only when TYPE=2.
Display data
Status: CPU 0/1, TSW 0/1, PLO 0/1 (0-3)
0=Not Mounted
1=Standby
2=ACT
3=Make-Busy