User's Manual

CHAPTER 8 NDA-24300
Page 618
Issue 1
SPTS: Scanning of Port Status
SPTS:
Scanning of Port Status
1. Functional Outline
This command displays momentarily the working status of Port Microprocessor (PM) on Module Group (MG),
Unit, and Group basis.
2. Parameters
Input data
MG
Unit
Group
Interval: Unit for this parameter is in seconds.
Entry Procedure
Type 1: By MG
Display of Scanning by Designating MG (Figure 8-1)
Package Status PM: Not Mounted
Note
ID: Idle at least one
BY: All Busy
MB: Under Make Busy Status
Note:
This information appears when the circuit card is in make busy status (MB key is set upward) or when
the designated location has no circuit card.