User's Manual

ND-70185 (E) CHAPTER 8
Page 187
Revision 3.0
EX- FCCS
Data Programming
STEP 2: ARTD
Assign the following three routes for this feature:
• Speech Path Route (Traffic Route)
• Signaling Route
• Dummy Route (Flag Route)
Assign each route data in accordance with the table shown below. Note that data assignment in this table is a
typical example.
The other data than above should be set “0” (default data).
STEP 3: ATRK
Assign the LENs data of the trunks. See Figure 8-8.
Figure 8-8 Port Allocation and Related Command for CCIS Trunk
Route
CDN
24567813152830434950
Speech 2234120121010/11
Signaling22041001307000
Dummy 0004101000000
(CCH Location)
MG
U G
XX X 10
(CCH Location)
MG
U G
XX X 12
(Reference 1)
• 24CCT is mounted in slot 10.
• Last TS (CH) is used for CCIS signal CH.
• RTx = Speech CH, RTy = Signal CH.
G15
G14
G13
G12
24CCT
ATR K
RTy TK1 (Signal CH)
ATR K
RTx (Speech CHs)
ATRK
RTy TK2 (CCH)
10Slot
ACSC
G15
G14
G13
G12
2CCH
ATR K
RTy TK1 (Signal CH)
ATR K
RTx (Speech CHs)
10Slot
ACSC
G11
(CCH#1)
G10
(CCH#0)
9
24DTI
ATR K
RTy TK2 (CCH)
Note
Note:
Only one CCH (CCH#0/CCH#1) can be assigned.
This example is applicable when CCH#0 is used.
(Reference 2)
• 24DTI is mounted in slot 10.
• 2CCH is mounted in slot 9.
• Last TS (CH) is used for CCIS signal CH.
• RTx = Speech CH, RTy = Signal CH.