User's Manual

CHAPTER 4 ND-70185 (E)
Page 50
Revision 3.0
INSTALLATION
Connecting Cables
Figure 4-13 Examples of Ethernet Cable Connection-FCH in PIM0 (1-IMG System) (2/2)
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
06040503020100
06040503020100
CN
CN
CN
CN
HUB
CN
CN
HUB
BASEU
PIM 1
PIM 2
PIM 3
UTP CTG5 ST CA-J
PIM 0
LPM
TOPU
FANU
BSCM
CN
FCH
CN
UTP CTG5 ST CA-J
FCH
CN
CN
UTP CTG5 ST CA-D
<FCH in PIM0 (Pattern 3)> <FCH in PIM0 (Pattern 4)>
06040503020100
06040503020100
CN
CN
CN
CN
CN
CN CN
UTP CTG5 ST CA-J
CN
FCH
HUB
CN CN
HUB
BASEU
PIM 1
PIM 2
PIM 3
LPM
CN CN
TOPU
FANU
PIM 0
CN
FCH
CN
UTP CTG5 ST CA-D
UTP CTG5 ST CA-J
BSCM
Note: When dual LANIs are used in both slot 00 and 03 of CPR (Pattern 3 or 4), be sure to use at least two HUB cards:
One HUB for internal LANI (in slot 00) and the other for external LANI (in slot 03: available for Release 3 or
later software). However, if this is the case and FCH is also in a dual configuration, the 10 BASE-T “cross”
connection between the HUBs is not required.