User's Manual

ND-70185 (E) CHAPTER 5

Page 63

Revision 3.0

DATA PROGRAMMING

Assignment of System Data

STEP 2: ASYDL

Assign the self-Fusion Point Code (self-FPC) at each node. FPC ranges from 1 to 253. Use the ASY-

DL command. (Index 512 b0-b7)

• Index 512 self-Fusion Point Code

Assign a unique FPC for each node.

Figure 5-6 Self-FPC Assignment

STEP 3: ASYDL and ASYDN

Assign other system data using the ASYDL/ASYDN command.

When Timing Start is used, assign the following data.

Index 161 b6 : 0/1=-/Timing Start using “#” code

b7 : 0/1=-/Timing Start using “*” code

Index 170 b4 : 0/1=Timing Start out of Service/Timing Start in Service

Note 1

Index 640 Fusion Point Code (FPC) of node providing ATTCON

Note 2

Index 704~735 (ASYDL)

FPC of the node to which ATTCON transfers the Day/Night changeover

information.

Note 3

Assign FPC of a terminating node for House Phone, Off-Hook Alarm and Ring Down (IC) calls from

PSTN. Day/Night information is transferred from the terminating node.

Note 1:

When Timing Start is in service, Called Sub Address for ISDN Network cannot be dialed.

Note 2:

This data is necessary at each node. Assign the self-FPC at the terminating node.

Note 3:

This data is necessary at the node providing ATTCON.

NCN: Network Control Node

LN: Local Node

NCN

This figure shows an example of FPC assignment. Assign a unique FPC for each node.

ASYDL Index 512 (b0-b7)