User's Manual

ND-70185 (E) CHAPTER 5

Page 81

Revision 3.0

DATA PROGRAMMING

Assignment of FCH Related Data

STEP 4: MBCT

Unbusy the connection trunk data assigned in the previous step using MBCT (Make Busy of Connec-

tion Trunk) command. This step is required for both B-channel and D-channel trunk. The MBCT

command should look similar to the following.

Figure 5-26 MBCT Command Display

7. Assignment of FCH Related Data

STEP 1: For Fusion with FCH only:

• Assign FCH Number on an FCH (PA-FCHA) circuit card basis.

• The FCH Number must conform to the following conditions:

• FCH Number range must be between 1 and 255.

• At the network level, the same FCH Numbers can be assigned. However, they must be unique at the

node level.

• Use sequential numbers starting from 1 as FCH Numbers.

MBCT (Make Busy of Connection Trunk Data)

MBCT (Make Busy of Connection Trunk for Local)

C_RT

C_TK

WRT?

C_RT: 1-1023

C_TK: 1- 4095

Make Busy Information

0: Make Idle

1: Make Busy (Outgoing)