User's Manual

CHAPTER 5 ND-70185 (E)

Page 84

Revision 3.0

DATA PROGRAMMING

Assignment of FCH Related Data

STEP 3: AFPC

Assign FCH routing data using the AFPC command. A maximum of 8 connection routes and FCHN/

FPCN can be assigned on a node basis. FCHN is used for Fusion System with FCH. FPCN is used

for Fusion System without FCH. The list box labeled FCH on the AFPC command determines the

system type. Assign “0” for Fusion System without FCH and “1” for Fusion System with FCH. In

this step, the explanation is given using the following network as an example. Figure 5-31 shows a

sample Fusion network. Each number in the circle represents the Fusion Point Code (FPC).

Figure 5-31 Fusion Network (example)

The AFPC command display (Fusion with FCH) should look similar to the following:

Figure 5-32 AFPC Command Display (example)

WARNING: The AFPC command affects communications between nodes. Change the data

with extreme care.

NCN: Network Control Node

LN: Local Node

This figure shows an example of Fusion network. Each number in the circle stands for Fusion Point Code (FPC).

Node C

NCN

C_RT=10

Node A

Node B

Node D

Node E

Node F

FCHN=1

FPC

For Help, press F1

CNT C_RT

FCHN/FPCN

CNT C_RT

FCHN/FPCN

AFPC (Assignment of FCCH Routing Data for Local)

FCCH

22 1

0: Fusion without FCH / 1: Fusion with FCH

Assign Destination FPC (far end FPC).

FCH number (1-255)