Manual

Fitting the intermediate panel

Note: During installation, make sure that the lettering "top right"

is upside down at the bottom left.

1. Insert the intermediate panel towards the back as far as it will

go (fig. A).

2. Hook in the seal on both sides (fig. B).

3. Insert the retainer (fig C).

4. Press down on the retainer until it locks into position (fig. D).

Fitting the door panel

1. Insert the door panel at an angle towards the rear into the

retainers (fig. E).

2. Press down on the side of the door panel until it locks into

place (fig. F).

3. Refit the appliance door.

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.

: Risk of burning due to hot components in the cooking

compartment!

Wait until the cooking compartment has cooled down.

1. Push the hook-in rack upwards at the front and unhook to the

side (figure A).

2. Pull the hook-in rack forwards at the rear and unhook to the

side (figure B).

3. Clean the hook-in rack with washing-up liquid and a sponge

or brush.

4. Align the hook-in rack with the indentation (a) facing

downwards, so that the shelf heights match.

5. Insert the hook-in rack at the rear as far as it will go and push

to the rear (figure C).

6. Insert the hook-in rack at the front as far as it will go and push

downwards (figure D).

%

$

)

(

$ %

& '