User's Manual

The transmitter is tuned for best performance through
8 mm (0.315") of Corian® solid surface. Instructions for optimum placement
and installation are in this bulletin. Due to the precise routing required the
installation should be done in the fabrication shop prior to sheet installation.
The OEM Module(Wireless Charging) – Individual package consists of the
transmitter, power cord and transformer. PMA-compliant charging rings are
available separately in packs of three: one ring each of micro USB, Apple 30-
pin and Apple Lightning® PMA compatible receivers.
The transmitter has a micro USB port for updating the firmware if necessary.
The USB port can’t be used by consumer, is manufacturer for updating the
firmware only.
Do not use the OEM Module(Wireless Charging) in the environment at too high
or too low temperature, never expose the device under strong sunshine or too
wet environment. The suitable temperature for the phone and accessories
is -10℃-40℃.
A. PREPLANNING
A.1. Box Contents
The box will come with the transmitter and the power supply (not pictured
here).
A.3. Placement
There are several considerations regarding proper placement of the transmitter:
• Avoid putting in proximity to locations where the device being charged
may get wet, exposed to excessive heat or any other conditions which
may damage the device being charged.
• Do not install next to heat sources (such as stoves) or where heat sources
are commonly used (toasters, hot plates, etc.).
• Stay away from edges where charging devices can be easily knocked off
the surface.
Work with the customer to determine convenient locations. Page 1 of 4