Installation Guide

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful

interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

This device complies with part 15 of FCC rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference

received, including interference that may cause

undesired operation.

Change or modiﬁcations that are not expressly

approved by the manufacturer could void the user’s

authority to operate the equipment.

RF Exposure Information

This equipment complies with FCC radiation

exposure limits set forth for an uncontrolled

environment. In order to avoid the possibility of

exceeding the FCC radio frequency exposure limits,

human proximity to the antenna shall not be less

than 20cm during normal operation.

Federal Communications Commission (FCC) compliance