User Manual

Fiber Tap HD8
5
Connecting to the Network
1. Connect Network Port A to the appropriate network device using a Duplex
LC cable.
2. Connect Network Port B to the appropriate network device using a Duplex
LC cable.
3. Verify that the Tap Network Ports are cabled in-line between two devices.
4. Repeat steps 1-3 as needed for remaining segements.
Note: ________________________________________________________________
The use of Singlemode (8.5µm) or Multimode (50µm or 62.5µm) cabling is
determined by the model purchased.
______________________________________________________________________
Figure 2: Connecting to the Network
To Network Device
To Network Device
Splitter Tap HD8Splitter Tap HD8
www.netoptics.com
A B AA BB
OUT IN OUT IN OUT OUT
A
B AA BB
OUT IN
OUT IN OUT OUT
A B AA BB
OUT IN OUT IN OUT OUT
1 2
4
3