Max 410/420/430 Internet Protocol Device User's Guide

Max 410/420/430 User’s Guide – Chapter 5
41
firewall for your Max 410/420/430 unit), you must
specify these open ports on the Max device(s):
a. Change the TCP Start Port to the port you
opened in step 1-c. For example, if you
opened TCPPORT 21057 in step 1-c, enter
21057 for the TCP Start Port as shown in
Figure 17, below, illustrating the Network
Configuration Table on the Network and
Voice Configuration page.
b. Change the UDP Start Port to the port you
opened in step 1-b. For example, if you
opened UDPPORT 21000 in step 1-b, enter
21000 for the UDP Start Port as illustrated in
Figure 17, below.
Figure 17 – Network Configuration Table
3. After you have made the desired changes, click
the Save button at the bottom of the page to save
the new settings, then restart the Max.
The new settings should now be in effect.
NOTE: Some firewalls require the opened
port to be forwarded to the Max’s IP
address. Consult your LAN administrator
to determine if this is the case with your
firewall.
Account Configuration
Click the Account Config link to access the Account
Information page, illustrated in Figure 18 below.