- NetComm Modem Router User Guide

44 NB9/NB9W ADSL2+ VoIP Router
YML790 Rev8
ADVANCED
Advanced > WAN
Clicking on the ‘Advanced’ menu displays the following:
This screen provides a summary of the current WAN interfaces you have configured. If you have connected
the NB9/NB9W to ADSL through the ADSL Quick Setup interface, details of the connection will be
summarised here.
Setting up a WAN profile goes through a set of steps which establishes connection parameters covering
the following:
Field Means
VPI/VCI
Always 8/35 in Australia
Con. ID
Sequence number of connection (e.g. 1,2…)
Category
ATM Service Category; leave as default
Service
Name of connection: give this a name you will recognise (e.g. ISP name)
Interface
Current WAN interface name
Protocol
Bridge or Router Mode
IGMP
Enable/Disable IGMP proxy
NAT
Enable/Disable NAT (leave enabled unless advised otherwise by tech support)
Firewall
Enable/Disable Firewall (leave enabled unless advised otherwise by tech support)
QoS
Enable/Disable QoS; enable if VoIP services are being used.
State
Enable/Disable this WAN connection
Once settings are entered, click Save. Connection status can be checked under Status>Diagnostics.
Choosing a WAN Profile
In the event that you wish to set up several connection profiles on your NB9/NB9W for use in different
locations OR with different ADSL services
• click ‘Add’ to add the next connection profile
• Repeat set up steps above
You are able to cycle through connection profiles in the Status>Diagnostics window; if more than one WAN
profile exists, a button will displayed for Next Connection in the sequence.