Network Adapter User Guide

V110, V210P, V211, V220 User Guide YML881Rev1
26 www.netcomm.com.au
User Name
Your VoIP number. This number is assigned by your VoIP service provider.
Auth Name
The authentication username assigned by your VoIP service provider. This can be
different to your VoIP number.
Auth Password
The authentication password provided by your VoIP service provider.
Subscribe for MWI
When enabled the Subscribe for Message Waiting Indication will be sent periodically.
Status
Indicates if the VoIP Gateway is registered to your VSP. If “Registered” is shown, you can
make and receive calls via your VoIP service provider. If the VoIP gateway reports “not
registered”, check the SIP Service Provider settings above and try again.
SIP Expiry Time
This setting specifies a recommendation to the SIP server on the re-registration interval.
Increasing this time will send less registration traffic, but can cause other issues.
Use DNS SRV
When DNS SRV is switched on, the VoIP Gateway will look up DNS SRV records and
register with the server with the highest priority. DNS SRV can provide redundancy if the
primary SIP server becomes unreachable. Please check with your VSP to find out if they
support DNS SRV.
Port Setting
You can configure the SIP and RTP port number in this page. Please leave as default unless otherwise
specified by your VSP.
Options Description
SIP Port
The port on the SIP server that receives requests from the ATA. Default: 5060.
RTP Port
The base port to receive RTP packets. Default: 60000.