Installation Guide

Installation Guide for the 9 dBi Omni-directional Antenna ANT2409
2-6
v1.0, April 2008
2. Locate the primary detachable antenna. Remove the antenna and connect the
other end of NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 to this port.
3. After attaching your new 9dBi antenna, reconnect your wireless device to the
network and turn it on.
Figure 2-6
Note: On access points with two antennas, if you are only replacing
one antenna, be sure to replace the primary antenna and do
not remove the secondary antenna.
(provided)