Owner's Manual
Table Of Contents
- Installation Guide
- User Manual
- Table of Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use Smart Setup to Connect the Extender to a Network
- Add a WPS Client to the Extender Network
- Change the Basic WiFi Settings
- Change WiFi Security Settings
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- View or Change the Internet IP Address Setting
- Enable NAT in the Extender
- Manage Profiles
- Operating Mode
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- Factory Default Settings
- Specs
12
Find the Best Location
If the WiFi signal is weak, the first time you join the extender network,
an arrow LED blinks for two minutes. If this happens, adjust the
position of the extender.
No arrow LEDs are lit. The extender is in a good location.
Left arrow blinks. Move the extender closer to the router.
Right arrow blinks. Move the computer or mobile device
closer to the extender.
Extender Performance
These extender LEDs indicate a WiFi connection:
WiFi signal between the router and the extender.
WiFi signal between the extender and the computer or mobile
device.
The LEDs are color coded:
• Green indicates the best connection.
• Amber indicates a good connection.
• Red indicates a poor connection.
An LED that is off indicates no WiFi connection.