Owner's Manual
Table Of Contents
- Installation Guide
- User Manual
- Table of Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use Smart Setup to Connect the Extender to a Network
- Add a WPS Client to the Extender Network
- Change the Basic WiFi Settings
- Change WiFi Security Settings
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- View or Change the Internet IP Address Setting
- Enable NAT in the Extender
- Manage Profiles
- Operating Mode
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- Factory Default Settings
- Specs
14
To connect an Ethernet-enabled device to your WiFi router
or access point:
1. Set up the extender.
For more information, see Place the Extender and Apply Power
on page 5.
2. Connect the extender to an existing WiFi network.
For more information, see Connect to an Existing WiFi Network
on page 5.
3. Plug the Ethernet cable from an Ethernet-enabled device to the
Ethernet port on the extender.