Owner's Manual
Table Of Contents
- Installation Guide
- User Manual
- Table of Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use Smart Setup to Connect the Extender to a Network
- Add a WPS Client to the Extender Network
- Change the Basic WiFi Settings
- Change WiFi Security Settings
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- View or Change the Internet IP Address Setting
- Enable NAT in the Extender
- Manage Profiles
- Operating Mode
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- Factory Default Settings
- Specs
18
Frequently Asked Questions
You can find more information about your product in the user manual,
which is available at http://support.netgear.com.
The web browser setup guide keeps asking me for my network
security key (passphrase), and I am sure I have entered the
correct passphrase. What can I do?
The extender is probably placed at the borderline of the range
covered by the router or access point. For more information, see
Place the Extender and Apply Power on page 5.
If you are using WEP security, make sure that you are typing the
wireless key in the correct field.
What are the user name and password to log in to the extender?
The user name is admin, and the default password is password.
Both are case-sensitive.
Will the extender work if I connect it to the router with an
Ethernet cable?
It depends. If the switch is set to Extender, the extender connects to
the router over WiFi. If the switch is set to Access Point, the
extender connects to the router with an Ethernet cable.