Owner's Manual
Table Of Contents
- Installation Guide
- User Manual
- Table of Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use Smart Setup to Connect the Extender to a Network
- Add a WPS Client to the Extender Network
- Change the Basic WiFi Settings
- Change WiFi Security Settings
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- View or Change the Internet IP Address Setting
- Enable NAT in the Extender
- Manage Profiles
- Operating Mode
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- Factory Default Settings
- Specs
Manage the Extender Network and Settings
18
AC750 WiFi Range Extender
Log In After Initial Setup
After installation, you can log in to the extender to view or change its settings.
To log in to the extender after the initial setup:
1. Connect a computer or mobile device to the extender
’s network.
2. Launch a web browser and enter www
.mywifiext.net in the address field.
A login screen displays.
3. Enter admin for the user name and password for the password.
If your extender has an Internet connection, the extender automatically checks for new
firmware at the NETGEAR website.
The Status screen displays.
Change the admin Password
The user name to access the extender is admin, and its default password is password.
NETGEAR strongly recommends that you set a more secure password.
To change the password for the extender:
1. On your computer
, launch a web browser.
2. In the address field of your browser
, enter http://www.mywifiext.net.