Reference Manual

Section 2 - RF Plan & provisioning Access Points
1. Starting position for this exercise: Any previously provisioned AP‟s were reset to factory
defaults and disconnected from the WFS, any previously existing buildings were deleted, old
entries were cleared from WFS database. Configuration was saved and WFS was rebooted.
2. Click on “Plan”. The following screen appears, with the default building setup which is to be
customised. Click “Building Dimension”.
3. On this screen, select “Unit” as Feet or Metres, and fill in the rest of the details. In this
example, the RF plan is only for the top floor of a 2-floor building, so “Floors” =1. Note that the
dimensions are for the full area covered by the floorplan .jpg that will be loaded at a later
step, which may be slightly larger than the area covered by the physical building. Click
“Apply”, then “AP Modelling Spec”.