Reference Manual

4. This screen shows the default Access Point parameters.
5. Edit the default AP parameters as required. “Coverage” will calculate required number and
location of APs based on the area to be covered, while “Capacity” will calculate this based on
number of users to be supported. 100% Overlap Factor indicates that the AP coverage areas
should just touch, increasing this parameter will make roaming more reliable. The parameters
specified on this screen will determine how many APs are required. Click “Apply”, then “AM
Modelling Spec.”.
6. The Air Monitor Modelling Parameter screen determines how many AMs will be required. In
most cases, default settings will be suitable. Click “Apply”, the “Save”, then “Planning”.