Reference Manual

13. Click “Initialize”. Air Monitor access point(s) will appear on the floorplan. Click “Start”. The
software will adjust the position of the AM‟s to optimize effectiveness. When it has finished,
you can manually drag AM‟s to specify the locations where AM‟s will really be installed (or
already are installed). It is important that this picture gives an accurate representation of
where the AM‟s are physically located relative to each other and the AP‟s. Click “Save”. The
RF plan is now complete. Make a note of the AP/AM location codes that have been generated
by the RF Plan (1.2.1 to 1.2.6 in the screenshot).