Reference Manual

Create a new VLAN
VLAN 1 is the default VLAN for the WFS709TP – by default all the ports (Fa1/0-7, Gig 1/8) are
members of VLAN1 – therefore access to the Controller Web Interface can take place connecting to
any of the ports.
To create a new VLAN, access the menu via Configuration – Basic - Network – VLAN.
This menu will allow creation of the VLAN, but the IP address assigned to the VLAN and the VLAN
Port membership will require to be setup separately.
To combine the setup of all the above settings please use the menu Configuration – Advanced –
Controller – VLAN as in the examples below.
The example shows how to create VLAN 100 and configure Port 0/6 and 0/7 to be part of the VLAN.
The result after apply the changes to both VLANs will be the following: