Owner's Manual

NETGEAR 108 Mbps Wireless PC Card WG511T User Manual
2-8 Network Connections and Wireless Security
v3.0, January 2007
To create an Ad Hoc mode profile:
1. Run the WG511T Smart Wizard.
a. Make sure the WG511T software is installed and the WG511T is fully inserted in an
available CardBus slot in your PC.
b. Use the icon to open the Smart Wizard. The Settings page opens.
c. Select Computer-to-Computer (Ad Hoc) for the Network Type.
d. Select or enter the Network Name (SSID) for the Ad Hoc network.
e. In the Profile box, type the name of the profile.
f. Click Apply.
2. Save your settings in a Profile.
a. Click the Save Profile button.
All the configuration settings are saved in this profile.
b. Click Apply.
Note: Ad Hoc mode will not work using DHCP settings. Ad Hoc mode requires either
static IP addresses (such as
192.168.0.1) or the IPX protocol. For instructions on
setting up static IP addresses on a Windows PC, refer to the PC Networking
Tutorial included on the NETGEAR CD.
Figure 2-6