Owner's Manual

NETGEAR 108 Mbps Wireless PC Card WG511T User Manual
Network Connections and Wireless Security 2-9
v3.0, January 2007
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
3. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
4. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
ping -t
192.168.0.1
and then click OK.
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to “reply.”
At this point the connection is established.
Note: For instructions on configuring static IP addresses, refer to the networking
tutorial on your NETGEAR CD.
Figure 2-7
Figure 2-8