User manual

Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its refrig-
erant circuit or insulation materials. The appliance shall
not be discarded together with the urban refuse and rub-
bish. The insulation foam contains flammable gases: the
appliance shall be disposed according to the applicable
regulations to obtain from your local authorities. Avoid
damaging the cooling unit, especially at the rear near
the heat exchanger. The materials used on this appli-
ance marked by the symbol
are recyclable.
Control panel
1 2 3 4 5
1
Pilot light
2
Temperature regulator
3
Fast Freeze light
4
Fast Freeze switch
Acoustic alarm reset switch
5
Alarm light
Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator clockwise to a me-
dium setting.
3. The Pilot light will light up and a sound is on only
for 2 sec. indicating that the appliance is powered.
4. The Alarm light will blink and the sound signal
alarm will get on, indicating that the temperature in-
side the appliance is too high.
5. Push the Fast Freeze switch and the sound signal
alarm will get off.
6. Push the Fast Freeze switch once again and the
Fast Freeze light will light up. The freezer will start
to operate.
Switching off
1. To turn off the appliance, turn the Temperature
regulator to the "O" position and a sound is on only
for 2 sec.
2. The pilot light will switch off.
Temperature regulation
The temperature within the appliance is controlled by
the Temperature regulator situated at the bottom of the
cabinet.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Fast Freeze function
You can activate the Fast Freeze function by pressing
the Fast Freeze switch.
The Fast Freeze light will light up.
It is possible to deactivate the function at any time by
pressing Fast Freeze switch.
The Fast Freeze light will switch off.
Excessive temperature alarm
If the temperature inside the freezer has risen to a point
where the safe storage of frozen food is no longer en-
4