Owner's manual

Slide the crimp ferrule onto the cable
- Position the labeling to the cabelend
Spread the braided shield
- position the pin on the center conductor
- Crimp the pin with the tool
- Pin can also be soldered (Optional)!
- Straighten the pin if misaligned.
crimp and push
the cable and leading ferrule to it`s end position until you
hear a snap noise.
Crimp the ferrule with the tool
(It`s easily with the Neutrik
“SHIELD-SPREADING-TOOL“!)
(For best crimping-results it is recommended to use the
original Neutrik tool - HXBNC with the corresponding insert)
(For best crimping-results it is recommended to use the
original Neutrik crimp tool
- HXBNC with the corresponding insert
or hexcrimp acc. to IEC 803-W (SW 1.7)
or squarecrimp acc. to IEC 803-2 (SW 1.6)
Prepare cable as shown
- Use an adjustable coaxial cable
stripper
Slide the leading ferrule on the cable
Crimp the pin
Insert the cable into the connector
Slide the ferrule over the shield to the front
H
Please note:
Position the connector body flush with the die face.
A
A
B
C
C
D
D
E
E
F
G
H
B
Slide the leading ferrule
under the shield!
C
R
I
M
P
O
P
ER
ATI
O
N
!
C: 5
[
.197î
]
B: 8
[
.315î
]
A: 15
[
.590î
]
Don't damage the foil!
(if existing)
Pin flush to the insulator
X
X
Labeling
Crimp ferrule
F
G
H
X
BNC 75 Cable Jack Panel Version - Tiny
|
Ω
ASSEMBLY INSTRUCTION
Draft. Nr.: BDA 130 Update: 02.04.2009/ 3102M1251
I I
Data subject to change without prior notice. 2009 NEUTRIK . ALL RIGHTS RESERVED.©
Æ
www.neutrik.com
NEUTRIK AG
NEUTRIK Zürich AG
NEUTRIK USA Inc.
NEUTRIK UK Ltd.
( )
LI
CH
USA
UK
T: F:
T: F:
T: F:
T: F:
+423 / 237 24 24 +423 / 232 53 93
+41 44 / 736 5010 +41 44 / 736 5011
+1 732 / 901 9488 +1 732 / 901 9608
+44 1983 / 811 441 +44 1983 / 811 439
NEUTRIK
NEU
TRIK France
NEUTRIK Tokyo Ltd.
NEUTRIK
Vertriebs GmbH
Ltd.Hong Kong
DE / NL / AT/DK
FR
JP
HK
T: F:
T: F:
T: F:
T: F:
+49 8131 / 280 890 +49 8131 / 280 830
+33 1 / 4131 6750 +33 1 / 4131 0511
+81 3 / 3663 4733 +81 3 / 3663 4796
+852 / 2687 6055 +852 /
2687 6052