Installation Guide

7
www.newageproducts.com
3
Installing Slatwall
Place bottom strip tight against the wall
aligning it to your marked level line.
Interlock bottom of Slatwall section with
the top of bottom strip. Repeat step 5 to
securely fasten
“Slatwall Section”.
Interlock Top Magnet Cover on top of the
slatwall section and secure in position
with magnets.
Recommended Heights:
4x4ft : 24-30 inches
2x8ft: 48 inches
Pre-drill 3mm (1/8”) holes into each stud
then fasten slatwall section to each wood
stud with screws provided
.
Repeat steps 4 & 5 to install additional
“slatwall sections”. For a 4x4ft conguration,
install 6 remaining sections. For a 2x8ft
conguration, install 2 additional sections.
Masonry.
4
5
7
6
• Follow steps 3 to 7.
• Drill pilot holes through the perforated
strip each 16in with hammer drill &
masonry bit.
• Use 2” x ⁄” Tapcon Concrete Anchor
for each pilot hole. (Not Included)
•OR use #8 x 2” Screw with masonry plug
for each pilot hole. (Not Included)