Instructions / Assembly

34
Lighting the Grill
Method 1 (Using Pulse Ignitor Button):
1. Read and complete PRE-GRILL checklist.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the “OFF” position.
4. Turn the control knob for the Burner to the “HIGH” position.
5. Press the Pulse Ignitor button and hold for 3–5 seconds to light burner.
6. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. To turn o, turn each control knob clockwise until it locks in the “OFF” position. This does not turn
o the gas ow from the cylinder.
8. Once the grill is lit, adjust the temperature using the Max -to- Min settings.
NOTES
• Any of the Burners can be lit rst using the Pulse Ignitor/ Match. It is upto the customer
preference and requirement.
• If Burners does not light or ame is too low, you may have spider or other insect blockage
inside or vicinity of the burner holes. See “Replace the Burners” section.
• The IR burner lighting process is similar to that of Main Burners.
Low
Temperature
Pulse Ignitor
High
Temperature