Instructions / Assembly

35
Lighting the Grill
Method 2 (Access Holes):
If the burners fail to light after a couple of attempts, it can be lit using the supplied match lighting
stick. Follow the steps below for manual grill lighting.
1. Read and complete PRE-GRILL checklist.
2. Make sure all control knobs are set to OFF.
3. Always light grill with lid open.
4. Turn fuel supply ON.
5. Place a match in the aligator clip on the match holder and light the match.
6. Guide the match holder, with lit match, through the access holes on the Flame Tamer Panel and
adjacent to the burner.
7. Push the corresponding control knob in and turn it to HIGH to ignite the left burner. Check that
the ame is lit by looking through the cooking grates. You should see a ame.
8. Repeat step 5 to 7 for the remaining burners. If any of the burners fails to ignite during the
lighting process, within ve seconds, stop, turn the burner control knob to OFF and wait ve
minutes to allow the gas to clear before you try again.