Instructions / Assembly

Burner Position and Flame Adjustment

CAUTION

Proper placement of each burner is critical after cleaning they must be centered on the brass

orice, resting level without any rocking. Failure to meet these conditions may cause a very

dangerous condition that can cause personal injury and property damage.

Turn o gas at source and disconnect the unit before servicing. To avoid the possibility of burns,

maintenance should be done only when the grill is cool. A leak test must be performed annually

and whenever any component of the gas train is replaced or gas smell is present.

Gas control knobs should be in the ‘OFF” position, and fuel line should be disconnected from gas

valve manifold. To reduce the chance of FLASHBACK, the procedure below should be followed at

least once a month or when your grill has not been used for an extended period of time.

Proper Flame

Improper Flame

LIGHT BLUE

DARK BLUE

SPUTTERING

FLAME

BURNER

Burner Position

Valve with Orifice

Image 2

Image 1

BURNER PORT

1. Check burner installation by insuring

that the valve orifice body is securely

inserted into the end opening of the

burner tube. (see Image 1)

2. To check for proper flame. Turn burner

on high and compare to (image 2) for

proper flame consistency. If you

observe improper flame behavior then

refer to page 37 for corrective actions.

YELLOW TIPPING

1” (26mm) Flame Height