Instructions / Assembly

48
Troubleshooting
PROBLEM POSSIBLE CAUSES
9. Electric Ignition (Pulse Ignitor)
not working properly
Gas supply is o
Check gas supply. Turn OFF and ON your gas supply and try lighting
again.
Ignition electrode not in correct position.
The distance from the tip of the electrode to the burner should be
4 mm.
Faulty Pulse Ignitor
If a spark occurs anywhere but the ignitor tip, replace the Pulse Ignitor.
Check to see if the grill will match-light. See “Manually Lighting the
Main Grill” section.
Spark is not produced
Check if Pulse Ignitor button is producing Snapping sound when
pushed. Remove the Cooking Grate and Flame Tamer Panel to check for
spark on the electrode as expected when Ignitor button is pushed.
Battery health
Make sure that AA battery is not oxidized and contains enough charge.
Check your ignitor battery and replace if needed. Check to see if debris
is blocking the electrodes. Is one of your burners turned on? Allow up
to four seconds of gas flow to ignite.
10. Burner goes out when set to
low
Supply hose is pinched.
Reposition supply hose as necessary.
Dirty or clogged orifice. Spider webs or other matter in venturi tube.
Clean burner orifice. Clean out venturi tube.