Use and Care Manual

STEP 1

Heater as received out of box. Before lifting outer shell

protect hands. Never grasp bare metal without hand

protection.

STEP 2

Lift outer shell straight up. Care must be taken to

protect hands during lift.

STEP 3

Lift outer shell until all three clips engage slots in lower

shell. When this happens, the screw holes will line up.

STEP 4

Lock the clip into place with 3 screws as shown. The

heater must not be operated unless the outer shell is

properly extended and fully locked into place.

CAUTION: NEVER IGNITE AND / OR RUN THIS HEATER UNLESS THE SHELLS ARE FULLY EXTENDED AND LOCKED

INTO POSITION.

Make sure the clip

goes into the slots

in the lower shell

(3 places).

Lock the shells together

with the clips in place

and with a screw in

each clip (3 screws

total).