Installation

3. TEST INSTALLED FAUCET
· Turn on water supply. Rotate the hot handle and hold until the tank fills up, (tank is full when water comes
out of the spout). Rotate hot handle to turn water off.
· Check all connections for leaks. Make any final adjustments as required by first turning off the water supply
to relieve the pressure.
· Plug in the water tank and wait between 10-15 minutes for water to reach its target temperature.
ATTACHING WATER CONNECTIONS TO SUPPLY AND TANK (See Fig 2)
· Connect blue tube to the cold water supply utilizing the 9/16 thread if available (dependent
on dispenser model) or the quick connect adapter. Do not trim this hose.
· Trim the clear/grey hose as short as possible to reduce back pressure, then, connect to the
center outlet tube on the top of the tank utilizing the brass coupling.
· Connect the red tube to heater tank inlet, utilizing a quick-connect fitting with filter (not
included). Debris Screen Filter protects Hot Water Tank from blockages. Warranty will be
void if Quick-connect fitting with filter is not used.
Figure 2
Water supply
(not included)
Blue tube
(Do not Trim)
Red tube
Clear/Grey tube
Tank inlet
Brass coupling
w/ insert
Inlet coupling
(not included)
Tank outlet
Hot water Tank
#5-036
2001 CARNEGIE AVE, SANTA ANA CA 92705
[phone]
WWW.NEWPORTBRASS.COM
NWP-106 Rev F
EN-4290
01/21/2021
9/16" available on
certain models