Installation Sheet
Installation Instructions
Single and Double Towel Bar / 2 & 3 Post Tissue Holder
Model No. 75-01, 75-02, 75-03, 75-04, 75-05, 75-28, 75-29
1. Using the table below, measure the appropriate distance between post centers. See Figure 1
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 5/16"
· 24" Single Towel Bar - 24 5/16"
· 30" Single Towel Bar - 30 5/16"
· 18” Double Towel Bar: 18-11/16”
· 24” Double Towel Bar: 24-11/16”
· Tissue Holder (2 Post) - 6 1/4"
· Tissue Holder (3 Post) - 6 1/4" (2x), See Figure 2.
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#10 x 1 3/4”) - use: 1/8" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Fasten FLANGE (1) to wall using either WOOD/TOGGLE SCREWS (2). See Figure 3.
4. Place ESCUTCHEON (3) onto FLANGE (1). See Figure 4.
5a. Towel Bars (Single): Assemble TOWEL BAR (7) between END POST (5).
Place END POST (5) onto FLANGE (1) and secure into place with SETSCREW (4). See
Figure 5.
5b. Towel Bars (Double): Take towel bar assembly and place END POST (5) onto
FLANGE (1). Secure into place with SETSCREW (4). See Figure 6.
5c. Tissue Holder (2 & 3 Post): Place END POST (5) onto FLANGE (1) and secure into
place with SETSCREW (4). Place HOLDER (6) between END POST (5). See Figure 7.
Fig. 2
3
1
Fig. 4
Fig. 5
5
4
4
6
5
1
Distance
between
posts
Distance
between
posts
Fig. 7
5
1
7
Fig. 6
1
5
4
2
Fig. 3
1
1
Recommended Installation by a Professional Contractor
Distance between
posts
Fig. 1
(949)417-5207
NWP-75-01 Santa Ana CA 92705 12/5/2011
www.brasstech.com