Installation & Assembly

Decking Installation Guide / v20191125US 13
DIAGRAM 14
DIAGRAM 17
DIAGRAM 18
DIAGRAM 15
DIAGRAM 16
4
Slide in the clips into the two grooves and
glide them along until they are on their
respective joists and then screwing down
onto the joists as shown in Diagram 15 and 16.
Diagram 18 below shows a completed staircase
from the side to get a better idea of how the nal
installation will look.
3
Now take the next board and have it
situated behind the bullnose profile as
shown in Diagram 14.
5
Finally, nish your last board by face xing
into the board at every joist as shown in
Diagram 17.
Note: Remember to pre-drill before face
fixing into the board. Also face fixing
must happen at a 90 degree angle and
must be at least 1” 1/2 by 1” 1/2 from the
ends and the width of the board.
Stringer
T-Clip
Face Screw
Riser
Starting Clip