Installation & Assembly

Decking Installation Guide / v20191125US 17
DIAGRAM 33
DIAGRAM 34
DIAGRAM 32
4
The nal installed clips should look like
Diagram 32.
Note: The locking clip is in the middle of
Diagram 32 to show the expansion and
contraction is happening in both directions.
For more information on how to install the
locking clips and their placement, check
page 8 of this installation guide.
Note: The following shows how to install the
mini gap clip system. A starting accessory
(MG-3/TC-5 (SC-25) ) still needs to be used to
install the rst board.
1
First, slide the MG-1A and MG-2A clips
into the grooves of the boards as shown in
Diagram 33.
2
Place a screw in the outside hole of the MG-
1A and MG-2A as shown in Diagram 34.
Option 4:
Mini Gap Clip Installation
Locking Clip (MG-2A)
MG-1A
DIAGRAM 35
DIAGRAM 36
3
Next, x the screw down into the joist as
shown in Diagram 35.
4
After xing all clips, push the next board into
the clips as shown in Diagram 36 and 37.
DIAGRAM 37