Installation & Assembly
Decking Installation Guide / v20191125US 2
Prior to installing any composite decking, it is recommended that you check with local building codes
for any special requirements or restrictions. The diagrams and instructions outlined in this guide are
for illustration purposes only and are not meant or implied to replace a licensed professional. Any
construction or use of NewTechWood must be in accordance with all local zoning and/or building codes.
The consumer assumes all risks and liability associated with the construction and use of this product.
Safety
When dealing with any type of construction project, it is necessary to wear appropriate safety equipment
to avoid any risk of injuries. NewTechWood recommends but is not limited to the following safety
equipment when handling, cutting, and installing NewTechWood: gloves, a respiratory protection, long
sleeves, pants, and safety glasses.
Tools
Standard woodworking tools may be used. It is recommended that all blades have a carbide tip.
Standard stainless steel or acceptable coated deck screws and nails are recommended.
Environment
A clean, smooth, at, and strong surface is needed to install NewTechWood’s products correctly. Please
check with local building codes before ever installing any type of decking. If installation does not occur
immediately, NewTechWood’s products need to be put on a at surface at all times. Never ever should it
be put on a surface that is NOT at.
Planning
Plan a layout for your decking before starting it to ensure the best possible looking decking for your
project. Building codes and zoning ordinances generally apply to permanent structures, meaning
anything that is anchored to the ground or attached to the house. So nearly every kind of decking
requires permits and inspections from a local building department. We recommend drawing out a site
plan of your proposed project that you intend to do to minimize errors and make your perfect decking.
Construction
NewTechWood UltraShield is NOT intended for use as columns, support posts, beams, joist stringers
or other primary load-bearing members. NewTechWood must be supported by a code-compliant
substructure. While NewTechWood products are great for retrots, NewTechWood’s products CANNOT be
installed on existing decking boards.
Static
Static can also be more prevalent in areas that are of higher altitude because the humidity is lower. For
these areas, be careful of using conducive objects such as metal railing and chairs as static shocks might
occur more often. A potential way to lower the amount of static shocks occurring is to apply Staticide
IMPORTANT:
Read All Sections Before You Start
For the most up to date information, please visit our website @ www.newtechwood.com