Installation Guide

INSIDE CORNERS

Sandstone and Ledgestone

Step 1

Determine how you plan to finish the corner as this will dictate the length of the corner.

Corners can be finished with ledger or ledger corners. For a ledger finish, the top of the

corner (the end with the lip on top) should be 1 ⅝" below the top of the flange on the top

panel. Dry fit if the top panel must be cut horizontally.

Step 2

Locate corner so that the bottom of the corner will be flush with the bottom of the

bottom panel. Screw thru the recessed channel at top, bottom and middle of each side of

the corner using at least a 4 ½" screw. Adhesive maybe applied to the blocks on the

back side of the corner, if appropriate for the installation.

Step 3

If more than one length of outside corner is required, stack the corners by locking the

male end at the top of the corner to the female end on the bottom of the corner.

CORNER INSTALLATION