Installation Guide

TRIM INSTALLATION

SANDSTONE LEDGER

Step 1

The Ledger makes an ideal transition

from other building materials. The Ledger

can attach in 3 different ways: The most

common installation is directly over the

top row of panels at the tongue. Alternate

installations are discussed in the

following pages.

Step 2

Measure the total length of Ledger required. It is important to end both sides of the wall

with finished ledger ends. It is best to take the total length, and cut equal amounts from

ledger pieces in the center of the wall. This allows a tight union between the pieces with

finished edges on each side. Measure and cut each ledger required for a center union and

cut each end square for a good fit. Use rasp to round edges on factory ends to enhance

appearance. Use touch-up paint on the rasped area.

Step 3

Toe Screw the Ledger to the underlying substrate, with screws placed a minimum of 16"

apart. Ledgers can also be attached by toe screwing underneath the ledger piece.

Step 4

Exterior applications require flashing if

other siding products are used above the

ledger. Flashing can cover screws used

to attach the ledger for professional

results.

Screw attachment prior to flashing

All products must be allowed to acclimate; removed from boxes and stored flat at the

installation site for a minimum of 48 hours or until properly acclimated prior to

installation. Heat and moisture cause expansion. Best results are obtained by installing

cool, dry product. NextStone does not warrant against gapping caused by expansion

and contraction.