Operation Manual

Niagara 9100 Series User Guide
ViewCast 125
Audio tab
Use the following table to configure the audio digital input settings for a Flash encoder.
Note: The choices in the drop-down list may vary.
Figure 131. Audio tab
To configure audio settings:
1.
In the Source field, select an audio source from the drop-down list.
IMPORTANT! The audio input must match the source connected on the back of the system
and your audio source.
2.
Select the Overlay Closed Caption check box to enable overlay closed captions. Field 1 CC1 is
the default setting.
3.
Click the audio Format from the drop-down list.
4.
Click the Audio Type from the drop-down list.
5.
Click the Bitrate from the drop-down list.
6.
Click the Audio Encoder from the drop-down list.
7.
Grab and drag the slider to adjust the Left Volume and Right Volume.
8.
(Optional) Select the Mute Audio check box to silence audio.
9.
Click Save Settings.