Operation Manual

Digital Inputs
152 ViewCast
Figure 160. Output tab
To configure output settings:
1.
Click on a Windows Media Capture Profile from the drop-down list.
Note: When you select ATT UVERSE PEG from the drop-down list, the Pixel Aspect Ratio
field displays (Figure 161). Select the Pixel Aspect Ratio from the drop-down list.
Figure 161. Pixel Aspect Ratio field
2.
Select Enable Pull.
3.
Enter a port number that the server will use to pull the stream.
4.
Select Enable Push.
IMPORTANT! Be sure to enter a port number not already assigned to another encoder. If
two encoders attempt to use the same port number, one or both encoders will fail to start.
5.
Enter a port number that the server will use to push the stream.
6.
Enter the Server name or IP address.
7.
Enter the Publishing Point.
Note: This field is optional.
8.
Enter the User Name.
9.
Enter the Password.
10.
Select Enable Scripting to embed closed captions.
Note: If you enable closed captions through the Osprey driver, you cannot enable scripting.