Operation Manual

Niagara 9100 Series User Guide
ViewCast 197
Start/stop an encoder through SNMP
Use the same steps to load and expand VIEWCAST-AVENCODER-MIB until
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.avencoderObjects.avencod
erTable.avencoderEntry.avencoderCommand.
To start/stop an encoder through SNMP:
1.
Use the same method to load and expand VIEWCAST-AVENCODER-MIB until
iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.avencoderO
bjects.avancoderTable.avencoderEntry.avencoderCommand.
2.
Set object ID to something like:
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.avencoder
Objects.avencoderTable.avencoderEntry.avencoderCommand.77.80.69.71 where
77.80.69.71 is the ID of the associated encoder.
Note: With ViewCast SNMP agent V2.0, the index to the encoder table is no longer
the encoder name but an integer ID. Therefore, in this command, set it to
something like:
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.aven
coderObjects.avencoderTable.avencoderEntry.avencoderCommand.10 where
‘10’ is the ID of the associated encoder.
3.
Specify correct IP address of the targeted ViewCast SNMP agent: xx.xx.xx.xx
4.
Verify the Port field is set to 161.
5.
Set SNMP version to v1.
6.
Specify community such as setpassword with community right of READ CREATE.
7.
Specify Set Value to start or stop.
8.
Send SNMP SET request message to the targeted ViewCast SNMP agent.
Start/stop all encoders per group through SNMP
Use the same steps to load and expand VIEWCAST-AVENCODER-MIB until
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.avencoderObjects.avencod
erGroupTable.avencoderGroupEntry.groupCommand.
To start/stop all encoders per group through SNMP:
1.
Set object ID to something like
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.avencoder
Objects.avencoderGroupTable.avencoderGroupEntry.groupCommand.71.114.111.117.1
12.49 where 71.114.111.117.112.49 is the ID of the associated encoder group.
Note: With ViewCast SNMP agent V2.0, the index to the encoder table is no longer
the encoder name but an integer ID. Therefore, in this command, set it to
something like:
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.aven
coderObjects.avencoderTable.avencoderEntry.avencoderCommand.20 where 20
is the ID of the associated encoder group.
2.
Specify correct IP address of the targeted ViewCast SNMP agent: xx.xx.xx.xx