Operation Manual

14
ETH1
AUD1
RT
AUD1
LFT
ASI1
ETH2
AUD2
RT
AUD2
LFT
ASI2
VID2
VID1
ETH1
ETH2
G
_
+
G
_
+
G
_
+
G
_
+
L AUD1 R
L AUD2 R
ASI1 ASI2
VID2
VID1
Balanced Audio
Unbalanced Audio
Note that the balanced audio rear I/O panel is only supported boards with hardware version 4 and
higher. The hardware version is available in the Product Tab in DashBoard.
Front Indicators
A similar set of indicators exist in the front of the board. These are visible when the frame front
door is opened. The indicator layout is depicted below.
The LED indicators are as follows:
 Status LED: indicates the overall status of the board.
o Green: no active alarm
o Red: at least one critical alarm present
When inserting a board in the frame, this LED will be red until the board starts operation.
At that point, it will turn green if there is no active alarm or stay red if there is at least one
alarm.
 Power OK LED: indicates that the power received from the frame is OK.
o Green: power OK
o Off: no power (or insufficient voltage – check the frame power status)
 VID 1 and VID 2 LEDs: these behave exactly the same as the corresponding rear I/O
panel indicators.
 AS1 1 and ASI 2 LEDs: these behave exactly the same as the corresponding rear I/O
panel indicators.
 ENC1 and ENC2 LEDs: these LEDs flash if the corresponding encoder is running, with
output available for routing to ASI, UDP or RTP. They will not flash if the encoder is