Operation Manual

Ethernet ports (i.e., it is not service-affecting). The IP addresses of the streaming ports may be

also automatically changed if they are in the same subnet as the control IP address above.

If you press and hold this switch when the unit is powered off, and then power up the unit while

holding the switch, the following actions will be performed:

 The control IP address, mask and gateway are reset to the factory defaults as described

above.

 The unit configuration is cleared.

 The unit reverts to the factory-installed firmware.

As before, the STAT LED will temporarily change color to acknowledge the command. When it

changes color, you can release the switch. You can use this feature in the unlikely event of a

corrupted firmware upgrade or a corrupted configuration.