Operation Manual

27
In the B264 Modular Encoder, it is also possible to configure DNS in the Control Tab. DNS
Servers configured in the Control Tab have priority over servers configured here.
Network Statistics Tab
The Network Statistics Tab is subdivided into the same tabs as the Network Configuration Tab,
namely Interfaces and DNS.
Network Statistics Interface Tab
The Interface Tab reports the current IP configuration of each Ethernet port, as well as their link
state and running status.
The following parameters are reported in the Network Statistics tab:
 Alarm on Link Loss: Reports the current setting of this parameter.
 IP Address: Reports the current IP Address for the port.
 Subnet Mask: Reports the current Subnet Mask for the port.
 Default Gateway: Reports the current Default Gateway for the port.
 Interface Speed: Reports the current setting for this parameter.
 Port 1/2 Link: This indicator has the following states:
o Link OK: The port has established link with the network connection.
o Half-Duplex Link: The port is set to Auto-Negotiate, and it has achieved
100 Mb/s Half-Duplex link with the network connection. Niagara Video does not
consider Half-Duplex links suitable for video communication. The port will
operate, but we recommend that this be addressed. If Alarm on Link Loss is set to
Yes, the Dashboard™ Card State will be yellow if there are no higher-priority
alarms present.
o No Link: The port does not currently have link. If Alarm on Link Loss is set to
Yes, the Dashboard™ Card State will be red and the Status LED in the front of the