Operation Manual

52
The example below illustrates the Advanced Audio controls when one additional audio is
enabled. In this example, Audio Channel 1 is set to MPEG-1 Layer II, from the analog input,
and Audio Channel 2 is set to Dolby Passthrough.
Advanced Tab – Mux Parameters
These parameters control the details of the audio/video multiplexing, and the (P)SI tables. If the
Output Protocol in the Encoder Connections Tab is set to RTMP, these parameters will not be
shown as RTMP does not use the Transport Stream container.
The following Mux Parameters are always available if the Output Protocol is not set to RTMP: