Operation Manual

71
If Dolby Passthrough is configured, one additional indicator is shown:
 Encoder 1/2 Passthrough: This indicator contains the status of the Dolby AC-3
Passthrough function. It may contain the following values:
o Dolby AC-3, xxx kb/s: this means that the data in the selected group/pair has
been correctly identified as Dolby AC-3; its bit rate is reported here.
o Unknown Format: this means that data is present in the selected group/pair, but
it is not Dolby AC-3.
o Not Present: this means that there is no data in the selected group/pair.
If Secondary Audio is Enabled, or if additional audio channels are enabled, then the status of
each audio channel will be displayed in the Status tab. The actual indicators displayed will
depend on the individual settings of each audio channel. The picture below shows an example
where both audio channels are embedded Dolby AC-3 Passthrough.
Audio 1
Indicators
Audio 2
Indicators