Operation Manual
79
IP Outputs Tab
IP Outputs receive data from connected encoders or the test packet generators, format this data
for transmission over UDP/IP, and send it with very precise timing over the Ethernet ports. The
B264 card supports up to 4 transport stream outputs per Ethernet port. IP Outputs have the
following specifications:
Formats supported:
o MPEG-2 Transport Packets over UDP/IP
o MPEG-2 Transport Packets over RTP/UDP/IP
Number of MPEG-2 Transport Packets per UDP datagram: fixed at 7.
Addressing support: unicast, multicast and broadcast.
Advanced control over the IP header fields available.
SMPTE 2022 FEC available
8
. The B264 supports one FEC session per Ethernet port.
IP Outputs: Configuration Tab
IP output stream can be created, configured, and removed using this configuration area. Before
any streams are created, the Configuration Tab appears as depicted below:
To create an IP Output stream, first select the desired Ethernet port in the Add Stream drop-
down box. Once that selection is made, the IP Output Stream Configuration is displayed, as
depicted below (Basic View). The configuration screen has two areas:
IP Output Parameters: these are the parameters specific to the IP Output configuration.
The set of parameters available for configuration depends on the View selection.
Input Selection Connection Parameters: these allow a connection to be made to the
output stream.
The Connection Parameters are common to all outputs, and will be described in the Connections
Tab section later in this document.
8
Previously known as Pro-MPEG FEC COP3.