Operation Manual

Analog Inputs
106 ViewCast
Figure 129. Output tab
To configure output settings:
1.
Click on a Windows Media Capture Profile from the drop-down list.
Note: When you select ATT UVERSE PEG from the drop-down list, the Pixel Aspect Ratio
field displays (Figure 130). Select the Pixel Aspect Ratio from the drop-down list.
Figure 130. Pixel Aspect Ratio field
2.
Select Enable Pull.
3.
Enter a port number that the server will use to pull the stream from the GoStream system.
4.
Select Enable Push.
IMPORTANT! Be sure to enter a port number not already assigned to another encoder. If two
encoders attempt to use the same port number, one or both encoders will fail to start.
5.
Enter a port number that the server will use to push the stream from the Niagara system.
6.
Enter the Server name or IP address.
7.
Enter the Alias.
Note: This field is optional.
8.
Enter the User Name.
9.
Enter the Password.
10.
Select Enable Scripting to embed closed captions.
Note: If closed captions is enabled through the Osprey driver, you cannot enable scripting.